Winland-electronics EA400 Manual do Utilizador descarregar pdf (Página 22)

20 D-011-0093

• At bottom of EA200 / EA400, pull the rear mounting plate down and away

from the EA200 / EA400 main chassis. The retainer tabs on the main chassis

will disengage from the holes in the rear mounting plate.

• Completely remove the mounting plate from the EA200 / EA400 main

chassis by disengaging the mounting plate upper hinges from the mating

tabs on the EA200 / EA400 main chassis.

2. Mount the mounting plate as follows:

• Mounting to 2-gang enclosure:

Use four (4) machine screws to secure the mounting plate to the mating

holes in the 2-gang enclosure.

• Mounting to drywall surface:

Place the mounting plate in mounting position. Mark the four mounting hole

locations. Install drywall anchors and secure the mounting plate to anchors.

Note: Where mounted to wall, a wiring access hole should be prepared at this time.

All wiring must pass through the opening in the center of mounting plate.

Winland_English.fm Page 20 Wednesday, July 5, 2006 1:33 PM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Sem comentários

Winland-electronics EA400 Manual do Utilizador Página 22